EntityProperties Apply SOLIDWORKS properties from measurement results |
EntityProperties allows to apply properties of measure to a part since any selection of entities SOLIDWORKS. With EntityProperties, reduce considerably the risks of errors or lapse of memory of update of the required values. Carry out, in a few seconds, the extraction of the dimensions of your crude (stored in your part) and thus produce documents and nomenclatures which integrate your rules of manufacturing. |
|
Videos of presentation |
View below a technical presentation of the tool EntityProperties.
|
Key features |
- Application of the generated properties on the document or specifically with the active configuration.
- Possibility of using filters of selection “Not, Edge, Face or voluminal bodies.
- Possibility of rename properties before insertion.
- Automatic recovery of the units of the document.
- Possibility of adding an offset according to the 3 directions to “ Gross able ”.
Get trained with the trainings
Go at the heading Training myCADtools.