Modification of a marking carried out with the tool MarkFoldLines, must be done in the '' modeunfolded state''.

This action can be necessary if, for example, the selected block is completely inside sheet or if its dimensions must be modified.

Two solutions are then possible:

  • The first solution consists with ''Edit Block'' of sketch. In this case all cuttings being based on this form will be also modified.


 


  • The second solution consists in modifying only one forms among cuttings. One then needs ''Explode Block''. In this case, only this form is modified, other cuttings are not impacted by the modification.


 


Typical case of the lines of folding on which cuttings are found inside the side.

 

  -->