• To create center points of the arcs and circles :

When circular edges, circles, arcs of a circle are selected, it is possible to specify if the coordinates to be extracted must be materialized by the creation of a point of sketch in the center. In this case it is necessary to check the options:


 


When the points of hang reference marks are asked, they are created in the view of work in mode outlines. In this case the annotation of reference mark is attached to this point.

In the case of selections of arcs of a circle (edge or sketch) and that the filter ''Intersection of the tangents'' is selected, two tangent lines forced at the ends of the arc and a point with this intersection is created in the view of work in mode outlines. The annotation of reference mark is attached to this point.


 


  • Layers :

All that is created by the tool GetCoordinates2D can be placed in specific layers.

It is necessary that these layers exist in the document of drawing.


 


It is thus possible to select these layers for the reference marks, the outlined entities and the tables of coordinates. If the modification of the layers is done after having begun the selection, the distribution of the generated entities will be made at the time of the validation of GetCoordinates2D.


    


  • To regard the arcs of a circle as circles :

If this option is checked , only the coordinates of the center, as well as the diameter, from the arcs of a circle (sketch or edge) will be extracted. The arcs are then regarded as circles.


 


If this option is unchecked , the coordinates of the ends of the arcs will be extracted as well as the diameter.