## Selection of points or summits

These choices are possible with the 2 methods of selection” 3D mode'' and ''Project mode''.

The points or summits belong to the model 3D or a sketch of the model 3D. The coordinates are extracted XYZ in ''3D mode'' and YY in ''Project mode''.

All the types can be checked or unchecked in only one action except for who cannot be activated with or .

The fact of clicking on this icon, removes all the lines generated in the table as well as the associated reference marks and the points possibly created. Numbering starts again with the value of beginning (just after the line “Origin”).

The fact of clicking on this icon, cancels the last selection. The line of the table and the associated reference mark are removed. Numbering starts again with the preceding value.

- Selection of Points/Summits :

The points or summits belong to the model 3D or a sketch of the model 3D. The XYZ coordinates are extracted.

The types of extraction are the following:

This icon makes it possible to extract the coordinates from any summit resulting from the intersections from 2 edges 3D or.

This icon makes it possible to extract the coordinates from all the points of sketch.

This icon makes it possible to extract the coordinates from the points of reference 3D (Geometry of reference/Not).

It is possible to select points of reference created in the model 3D. To do this, the selection of points must be made from the FeatureManager via the tabs. The selection is not possible in the view of drawing.

This icon makes it possible to extract the coordinates from the centres of mass 3D (Geometry of reference/Centre of mass). The selection can be done in the view of drawing.

- Selection of circle, arc of a circle, ellipse and portion of ellipse :

The entities are edges or entities of sketch model 3D. One extracts coordinates Xc, Yc, Zc of the center.

One extracts the coordinates X1, Y1, Z1 and X2, Y2, Z2 (3D mode) or X1, Y1 and X2, Y2 (project mode) of the 2 points of ends for the arcs and the partial ellipses.

One extracts the value R from the ray (or D of the diameter) for the arcs of a circle and the circles.

This icon makes it possible to extract the coordinates from the circles of sketch or the circular edges. A to combine with the options.

This icon makes it possible to extract the coordinates from the arcs of a circle of sketch or the circular edges. A to combine with options.

This icon makes it possible to extract the coordinates from the ellipses of sketch.

This icon makes it possible to extract the coordinates from the ellipses partial of sketch.

This icon makes it possible to extract the coordinates from the point of intersection generated by the tangent lines of an arc of a circle or a circular edge. this icon cannot be combined with and .