• Annotation of edge:

In the case of an annotation of edge, the line of fastener used is that defined in the options of the document SOLIDWORKS.

It is enough to enter the values of tolerance then to select a summit to hang the annotation which will position immediately. The repositioning will be able once to be made the closed tool (Modification/Edition).


 


  • General annotation:

In the case of a general annotation, the line of fastener and the geometries complementary are directly drawn in the annotation.

It is about an annotation which regulates the general tolerances on the nondefinite edges.

The annotation is placed where the cursor is placed and will never be attached to a summit.

    • General annotation applicable to all the edges.

 Drawing of a line of fastener and an interior angle containing the tolerance.

    • General annotation applicable to all the external edges.

 Drawing of a line of fastener and an interior angle containing the tolerance as of an exterior angle fixed on the arrow of the line of fastener.

    • General annotation applicable to all the interior edges.

 Drawing of a line of fastener and an interior angle containing the tolerance as of an interior angle fixed on the arrow of the line of fastener.

    • Exception to the general indications of edges.

 If, within the framework of a general indication, it is necessary to emphasize that another state of edge is necessary elsewhere in drawing, an additional indication must appear between brackets.