This type of selection is used to generate a series of points along the isoparameters of a surface. These points are created in a 3D sketch.

It is necessary to select a surface (and only one) and a starting point.

By default only points belonging to the restricted area are created.

For both distribution modes, the limits of the restricted area, represented by the parameters U and V max and min, are determined automatically. The parameters U and V of the selected starting point are also displayed.


 


This point must be located on the selected side. If the selected point is not on this side, a message warns the user.


 


Some common options to these two allocation methods may affect the results obtained.