• Create points at the centers of arcs and circles :

When circular edges, circles, arcs of circles are selected, it is possible to specify if the coordinates to be extracted must be materialized by the creation of a sketch point at the center. In this case you have to check the options :


When marker hotspots are requested, they are created in the working view in sketch mode. In this case the marker annotation is attached to this point.

In the case of arc selections (edge or sketch) and that the '' filterIntersection of tangentsWhen the '' is selected, two constraint lines tangent to the ends of the arc and a point at this intersection are created in the Sketch mode work view. The marker annotation is attached to this point.


 


  • Layers :

Everything created by the tool GetCoordinates2D can be placed in specific layers.

It is necessary that these layers exist in the drawing document.


 


It is therefore possible to select these layers for the markers, the sketched entities and the coordinate tables. If the modification of the layers is done after having started the selection, the distribution of the generated entities will be done at the time of the validation of GetCoordinates2D.


   


  • Consider arcs as circles :

If this option is checked In the case of a circle, only the coordinates of the center and the diameter of the arcs (sketch or edge) will be extracted. The arcs are then considered as circles.


 


If this option is unchecked The coordinates of the ends of the arcs will be extracted as well as the diameter.