The modification of a marking made with the MarkFoldLinesmust be done in the '' mode ''.unfolded state''.

This action may be necessary if, for example, the selected block is completely inside the sheet or if its dimensions need to be changed.

Two solutions are then possible:

  • The first solution is to ''Edit block'' of the sketch. In this case, all cuts based on this shape will also be modified.


 


  • The second solution consists in modifying only one shape among the cuts. It is then necessary to ''Explode the block''. In this case, only this shape is modified, the other cuts are not affected by the modification.


 


Special case of folding lines where the cut-outs are inside the sidewall.

 

 -->