• Create points at the centers of arcs and circles:

When circular edges, circles, or arcs are selected, you can specify whether the coordinates to be extracted should be represented by creating a sketch point at the center. In this case, check the following options:


When dimension anchor points are requested, they are created in the working view in sketch mode. In this case, the dimension annotation is attached to that point.

When selecting circular arcs (edge or sketch) and the "Tangent Intersection " filter is selected, two constrained lines tangent to the ends of the arc and a point at their intersection are created in the working view in sketch mode. The reference annotation is attached to this point.


 


  • Layers:

Anything created by the GetCoordinates2D tool can be placed on specific layers.

These layers must be present in the drawing document.


 


It is therefore possible to select these layers for reference marks, sketched features, and coordinate tables. If the layers are modified after the selection has begun, the generated features will be distributed when GetCoordinates2D is executed.


   


  • Treat arcs as circles:

If this option is checked Only the coordinates of the center, as well as the diameter, of the circular arcs (sketch or edge) will be extracted. The arcs are then considered as circles.


 


If this option is unchecked the coordinates of the ends of the arcs will be extracted, along with their diameters.