This module lets you angle the edges of existing parts. The PropertyManager offers 2 tabs for choosing between "Flat bevelling" (by extrusion) and "Domed bevelling" (by sweeping).
|
|
 Value and angle of the bevel.
 Allows you to define on which side there is clearance or not as well as the values (see sketch below to see where the construction dimensions are).
 The options allow you to define the names of the functions and to indicate whether they should be stored in a SOLIDWORKS folder or not.
 The dimensions for the clearance are set here.
|
Curved bevel - To obtain a bulge you must select this tab.
