Visiativ myCADtools

This type of selection allows you to generate a series of points along the isoparameters of a surface. These points are created in a 3D sketch.

You must select one (and only one) surface and a starting point.

By default, only points that belong to the restricted surface are created.

• Distribution according to an isoparametric grid.
• Distribution based on the number of points.

For both distribution modes, the boundaries of the restricted area—defined by the maximum and minimum U and V parameters—are determined automatically. The U and V parameters of the selected starting point are also displayed.

This point must be located on the selected side. If the selected point is not on this face, a message warns the user.

Certain options common to both of these allocation methods may affect the results obtained.