The names of drawings, sketches, and folders created in the FeatureManager follow the name specified in the "Options" section.

When plans are created automatically using the "Plan Repetition" and "Plans Along a Skeleton Curve" methods, the plans, sketches, and folders are automatically named using a root specified in the options. This root is incremented by a counter. The sketch name is the same as the name of the created plane.

Here are the naming conventions:

  • Folder names consist of the " Name" followed by the entity type "Plan" or " Section" (which may be incremented).
  • For generated entities:
    • The names of the plans use the " Name" (which may be incremented)
    • The names of sketches consist of the "Name" (possibly incremented) preceded by "E_" for 2D sketches and " E2D_" for 3D sketches if no drawing has been created. If a drawing is created, the name of the drawing is added to the sketch name.

Where SectionX is the root: SectionX_1 -> E_PlanX_1, SectionX_2 -> E_PlanX_2, ..., SectionX_80 -> E_PlanX_80.

Since a large number of plans can be created, they are grouped into folders to reduce the load on the FeatureManager (one folder per launch of the utility). The “Name” is also retrieved and used as the root of each folder’s name, with the value incremented.

Example:

  


Here is the result:

The folder containing the finished drawings comes before the folder containing the sketches.

 


Of course, if no floor plans are created or if you use the " Select Existing Floor Plans " method, no floor plan folder is created.