These choices are possible with the 2 selection methods ''.3D mode'' and ''Projected mode''.

Points or vertices belong to the 3D model or to a sketch of the 3D model. Coordinates are extracted XYZ in ''.3D mode'' and YY in ''Projected mode''.


 


All types can be checked or unchecked in a single action, with the exception of which cannot be activated with or .

Clicking on this icon deletes all lines generated in the table, as well as any associated markers and points. Numbering restarts at the beginning value (just after the "Origin" line).

Clicking on this icon cancels the last selection. The table line and associated marker are deleted. Numbering restarts at the previous value.


  • Points/Summits selection :

Points or vertices belong to the 3D model or to a sketch of the 3D model. XYZ coordinates are extracted.

The extraction types are as follows:

This icon is used to extract the coordinates of any vertex resulting from the intersection of 2 3D edges or .

This icon is used to extract the coordinates of all sketch points.

This icon is used to extract the coordinates of 3D reference points (Reference geometry / Point).

It is possible to select reference points created in the 3D model. To do this, points must be selected from the FeatureManager via the tabs. Selection is not possible in the drawing view.


 


This icon is used to extract the coordinates of 3D centers of mass (Reference geometry / Center of mass). Selection can be made from the drawing view.


  • Circle, arc, ellipse and ellipse portion selection :

Entities are edges or sketch entities 3D model. The coordinates Xc,Yc,Zc of the center are extracted.

We extract the coordinates X1,Y1,Z1 and X2,Y2,Z2 (3D mode) or X1, Y1 and X2, Y2 (projected mode) of the 2 end points for arcs and partial ellipses.

We extract the value R for the radius (or D for the diameter) for arcs and circles.

This icon is used to extract the coordinates of sketch circles or circular edges. To be combined with options.

This icon is used to extract the coordinates of sketch arcs or circular edges. To be combined with options.

This icon is used to extract the coordinates of sketch ellipses.

This icon is used to extract the coordinates of partial sketch ellipses.

This icon is used to extract the coordinates of the intersection point generated by the tangent lines of a circular arc or circular edge. This icon cannot be combined with and .