Visiativ myCADtools

This utility can only be run in the '' environment ''.Part''.

There are 2 ways to extract values to create properties:

• The ''Measurement Mode''.
• The Mode Swallow Box''.

In both modes the properties selected in the results table can be created:

• Either for the document, the properties are created in the tab ''.Customize'' of the properties.
• Either for the active configuration, the properties are created in the tab ''.Configuration specificThis is the case for the properties and for the configuration in use.

At each launch of ''EntityProperties'' and validation a ''EntityProperty'' is created.MacroFeature'' is created in the FeatureManager.