For both the "Measurement" and "Enveloping Box" modes, you can specify the names of the properties to be created. To do this, simply double-click in the corresponding cell in the " Property " column.

The units are those defined in the SOLIDWORKS document options.

Use the horizontal arrows on the keyboard to move the cursor within the cell.


 


The last column allows you to select or deselect properties in the table to specify which ones will be created for the "document" or for the "active configuration."

This last column is not present in "Enclosing Box" mode. The three properties will be created by default.


 


Example 1: I launch the “EntityProperties” tool in “Measurement” mode, select the solid, and specify that the “Density” property should not be created; then I confirm the function. Only the other three properties are created in the part’s “Customize” tab.


 


 


Example 2: I launch the “EntityProperties” tool a second time in “Measurement” mode, select two edges, specify that the properties should be created in the “Active Configuration,” and confirm the function. The two properties are created in the “Configuration-Specific” tab for “Plate 80.”